ENGINE MECHANICAL (C22NE, 22LE, 20LE) 6A-49
Starter Ring Gear (Manual Transmission)
Removal
1. Remove flywheel according to the corresponding
operation.
2. Drill starter ring gear underneath tooth gap approx.
8mm/0.30in. deep with 8mm/0.25in. diameter drill.
3. Separate starter ring gear with chisel on the drilling point.
Installation
1. Install starter ring gear with inner chamfered edge to
flywheel.
2. Heat starter ring gear evenly to 180°C /356°F to 230°C
/446°F (yellow paint mark)
3. Install flywheel according to the corresponding operation.
Inspection
Lateral run-out of starter ring gear - max. 0.5mm/0.02in.
To Next Page
Loading...
