2. Apply molybdenum disulfide grease to the
flywheel bolt threads.
3. Install the flywheel. Use the locating pin.
4. Tighten the fixing bolts to the specified torque in
three steps.
Follow the numerical order shown in the
illustration.
Torque :
1st step : 78 N·m (8.0 kgm/58 lbft)
2nd step : 60 deg.
3rd step : 60 - 90 deg.
NOTE : The flywheel housing bolts can be reused 6
times before replacement.
7. Install the oil pan with new gasket to the cylinder
block.
Refer to “Oil Pan Installation” in this manual.
ENGINE MECHANICAL 6A–75
015EY00175
To Next Page
Loading...
