ENGINE MECHANICAL 6A–105
1. Install the crankshaft gear to the crankshaft (if
necessary).
1. Install the crankshaft timing gear alignment pin.
2. Heat the crankshaft gear evenly with a gas burner
to invite thermal expansion.
Do not allow the temperature of the gas burner to
exceed 180°C (356°F).
If the crankshaft gear is not heated, it may break
during installation.
3. Use the crankshaft gear installer 8-94396-819-0 to
install the crankshaft gear.
The crankshaft gear timing mark L (1) must be facing
out.
Take care not to damage the crankshaft and crankshaft
gear.
WARNING: TAKE CARE NOT TO BURN YOURSELF
ON THE HEATED CRANKSHAFT GEAR.
015EY00131
To Next Page
Loading...
