38
2. ENGINE STARTING
(1) Pre-starting Preparation
1) Make sure that all hydraulic control levers etc. on the equipment are in
the NEUTRAL position.
2) Set the engine stop knob in the START position. (It is unnecessary for
the engine equipped with the engine shutdown switch.)
3) Switch ON the battery switch (if so equipped).
4) Insert the starter switch key into the switch key hole.
Turn the key clockwise to DRIVE position and, make sure that the
meters and warning lamps are actuated.
OFF
DRIVE
START
AUTO RETURN
IMWG0014
In case of the type with QOS system
IMLE0041
In case of the type with control resistance
To Next Page
Loading...
