61
Oil filter element installation
1) Apply lightly engine oil to the O-ring.
2) Turn in new cartridge until its sealed face comes in contact with
the O-ring.
3) Use a filter wrench to further turn in the cartridge.
Oil filter element tightening torque : 14.7 – 20.6 Nm (1.5 – 2.1 kgm)
Engine oil refilling
1) Disconnect the oil drain hose and reinstall the cap of drain cock. (One -
touch type)
Install the drain plug. (Drain plug type)
2) Fill with new engine oil by the oil filler port.
Wait about fifteen minutes until the oil gets down to the oil pan.
Then check the oil level with a dipstick.
Do not insert the dipstick by force. The dipstick may be broken.
WARNING:
1. In adding oil, take care not to spill it. If you spill oil, wipe it
properly, or this could lead to a fire.
2. Do not leave any flammables such as cloth or gloves in the
engine compartment. It may result in a fire.
IMWG0034
To Next Page
Loading...
