ARMY TM 9-2815-254-24
AIR FORCE TO 38G1-94-2
e.
f.
g.
h.
i.
Apply an ample coat of engine lubricating oil (MIL-L-2104) to crankshaft journals and crankshaft hearing sur-
faces.
FlGURE 3-94. Crankshaft Bearing Location
Install hearing halves (10, FIGURE 3-77) on engine block and install crankshaft (19).
Apply an ample coat of engine lubricating oil (MIL-L-2104) to thrust hearings (9) and install them to crankshaft
center journal with grooves facing crankshaft web.
Install lower halves of hearings (10) in main bearing cap and rod cap (3).
Perform following for bearing cape No. 1 and No. 5.
(1) Apply sealing compound (FORMAGASKET2) to inside surfaces of new arch gaskets.
(2) Use your fingers and push arch gasket into groove of No. 1 and No. 5 hearing caps.
NOTE
Use care not to scratch outer surface of arch gasket.
(3) Check that arch gasket projectioni is 0.0 to 0.0002 in. (0. to 0.005 mm).
3-144
To Next Page
Loading...
