ARMY TM 9-2815-254-24
AIR FORCE TO 38G1-94-2
(3)
Insert cylinder liner into cylinder block from top, refer to FIGURE 3-115.
FIGURE 3-115. Cylinder Liner Installation
(4)
Set cylinder liner installer (320903) on top of cylinder liner, refer to FIGURE 3-116.
(5)
Position cylinder block so installer center is directly beneath arbor press shaft center.
NOTE
Check that cylinder liner is set perpendicular to arbor press and that
there is no wobble.
(6)
Using arbor press, apply a seating force of 1102.5 lbs (500 kg) to cylinder liner.
(7) Apply a force of 5512.5 Ibs (2500 kg) to fully seated cylinder liner.
(8)
Measure cylinder liner projection, refer to paragraph 3-32.2, step c.
3-170
To Next Page
Loading...
