4-4
CONTROLS AND INSTRUMENTS
Make sure that the switches, including those for the windshield wiper, light control and
air conditioner, are in the "OFF" position.
Turn the starter switch to the "ON" position to check that the warning and indicator
lights turn on normally and the fuel level is proper.
When the starter switch is turned to the "ON" position, indicator lights which are not
applicable to your vehicle may turn on. This is for checking the light and does not
indicate a failure.
Starting the Engine
Starting the Engine
ADVICE
Using a key sticking with dirt or dust, etc. may possibly damage the starter
switch. Make sure to wipe off any dirt or dust, etc. before inserting the key.
•
WARNING
Do not keep the starter switch in
the "START" position for more than
about 10 seconds. Operating the
starter for too long might cause
battery failure or might result in
overheating and even a fire.
•
Starter Switch → Refer to page 4-74
Type 1
Type 2
LOCK
ACC
ON
START
4608498sec04CONTROLSANDINSTR4-44-44608498sec04CONTROLSANDINSTR4-44-4 2015/11/0213:58:302015/11/0213:58:30
To Next Page
