Isuzu FSS - Page 140

4-6
CONTROLS AND INSTRUMENTS
1. If your vehicle is equipped with
manual transmission, fully press the
clutch pedal.
If your vehicle is equipped with
Smoother, make sure that the
gearshift lever is in "N" and firmly
press the brake pedal. If your
vehicle is equipped with automatic
transmission of the selector lever
type, make sure that the selector lever
is in "N" and firmly press the brake
pedal.
If your vehicle is equipped with an
automatic transmission of the selector
button type, make sure that the shift
selector display shows "NN" and
firmly press the brake pedal.
Glow plug indicator light
2. Turn the starter switch to the "ON"
position.
When the glow plug indicator light
comes on, wait until it comes off.
But, depending on the condition, the
indicator light will not come on.
Glow Plug Indicator Light
V
→ Refer to page 4-64
3. Make sure that the glow plug indicator
light has come off, and then turn the
starter switch to the "START" position
to start the engine.
Use the idling control knob to
stabilize the engine speed when
the engine runs rough during warm-
up, regardless of the position of the
warm-up switch.
When your vehicle has warmed
up, fully turn the idling control knob
counterclockwise and run the engine
at idle.
Idling Control Knob
→ Refer to page 4-76
Warm-Up Switch
V
→ Refer to page 4-78
4608498sec04CONTROLSANDINSTR4-64-64608498sec04CONTROLSANDINSTR4-64-6 2015/11/0213:58:302015/11/0213:58:30