Isuzu FSS - Page 146

4-12
CONTROLS AND INSTRUMENTS
The analog tachograph records vehicle
speeds, time, distance traveled and other
information. The tachograph can be useful
in achieving economic driving and optimum
management of operation.
Refer to the separate instruction manual
for the analog tachograph for details of its
operation.
 
Analog Tachograph
V
ADVICE
Before opening the analog tachograph to replace the chart or for other
purposes, stop the engine. Otherwise, the tachograph may not work properly.
•
NOTE
When you turn the starter switch to the "ON" position, the odometer / trip meter
shows what was displayed the last time you turned the switch to the "LOCK"
position.
You can set the odometer to display on the odometer / trip meter each time you
turn the starter switch to the "ON" position. To do this, turn the starter switch to
the "LOCK" position while the odometer is being displayed, and then, with the
select / reset button pressed, turn the starter switch to the "ON" position. Within
3 seconds after turning the switch to the "ON" position, turn the starter switch
back to the "LOCK" position. Follow the same procedure to cancel the setting.
•
•
4608498sec04CONTROLSANDINSTR4-124-124608498sec04CONTROLSANDINSTR4-124-12 2015/11/0213:58:322015/11/0213:58:32