4-49
CONTROLS AND INSTRUMENTS
Smoother Warning Light
SA
Smoother Warning Light and Warning
Buzzer Operation
→ Refer to page 4-127
This warning light should remain on for
approximately 2 seconds after the starter
switch is turned to the "ON" position, and
then should go out.
This warning light should flash when the
Smoother emergency switch is placed in
the "ON" position, and should go out when
the switch is placed in the "OFF" position.
If this warning light comes back on after
turning off, or if it comes on while driving,
the Smoother system is not functioning
properly. Promptly have your vehicle
inspected at the nearest Isuzu dealer.
ADVICE
If this warning light flashes while driving, the Smoother oil is abnormally hot. Pull
off to a safe place well clear of traffic as soon as possible. Do not start driving
again until the warning light goes out.
•
CAUTION
If this Smoother warning light comes on, the following conditions may occur.
Also, vehicle movement during regular operation may become abnormal, such
as difficulty during speed adjustments at very low speeds, or the inability to
pull up to loading platforms correctly. In such cases, operate the vehicle while
paying close attention to your surroundings and promptly have it inspected at
the nearest Isuzu dealer.
Creeping does not occur
Shifting up or down cannot be performed
The timing for the clutch is faster or slower than usual
•
-
-
-
4608498sec04CONTROLSANDINSTR4-494-494608498sec04CONTROLSANDINSTR4-494-49 2015/11/0213:58:462015/11/0213:58:46
To Next Page
Loading...
