Isuzu FSS - Page 204

4-70
CONTROLS AND INSTRUMENTS
Warning
Buzzer
pattern
Location
Condition
In cab
Outside
cab
Brake system
AHB
Continuous
beep
•
×
Parking brake is released when
brake fluid level is too low.
Low air pressure
Continuous
beep
•
×
Parking brake is released when air
pressure is below specification.
Engine overheat
Continuous
beep
•
× Engine has overheated.
Engine overrunning
V
Continuous
beep
•
×
Tachometer needle goes in the red
zone.
Power cab tilt in operation
V
Long,
repeated
beeps
×
•
To tilt the cab up, pump lever is
placed in "UP" position.
To lower cab, pump lever is placed
in "DOWN (driving)" position.
Backing up
V
Long,
repeated
beeps
••
Gearshift lever/selector lever/
selector button is placed in "R"
position.
Parking brake inactive
(when brake lock is in
operation)
V
Continuous
beep
•
×
The parking brake is disengaged
or is insufficiently applied when
the brake lock switch is "ON".
Loss of air pressure or
brake fluid pressure
(when brake lock is in
operation)
V
Continuous
beep
••
A brake fluid leak exists or air
pressure falls below the specified
pressure when the brake lock
switch is "ON" and the parking
brake is engaged.
Over speed
V
Short,
repeated
beep
•
×
Vehicle speed is 120 km/h (75
MPH) or more.
Hill start aid (HSA)
V
Refer
to page
4-156.
*
× Refer to page 4-156.
Smoother
SA
Refer
to page
4-127.
*
× Refer to page 4-127.
•: Long lasting alarm ×: No alarm
*
: Refer to "Condition" column.
Warning Buzzer
A warning buzzer sounds under the following conditions.
4608498sec04CONTROLSANDINSTR4-704-704608498sec04CONTROLSANDINSTR4-704-70 2015/11/0213:58:532015/11/0213:58:53