4-83
CONTROLS AND INSTRUMENTS
Exhaust Brake Switch
To apply the exhaust brake while driving,
pull the lever rearward. The exhaust brake
indicator light comes on. To disengage
the exhaust brake, press the accelerator
pedal or the clutch pedal (if your vehicle is
a manual transmission vehicle). Releasing
the pedal reengages the exhaust brake.
• If your vehicle is equipped with a
Smoother, the exhaust brake is
disengaged during gear shifting or
when the engine speed is reduced
before the vehicle comes to a stop.
The exhaust brake reengages when
gear shifting is completed or when the
engine speed increases sufficiently.
CAUTION
It is extremely dangerous to apply the exhaust brake on slippery roads (with
their surfaces covered with compacted snow, frozen, or wet) as the tires can
skid.
•
Exhaust brake indicator light
Hazard Warning Flasher Switch
The hazard warning flasher is used to
signal other vehicles that your vehicle is
stationary on the road because of accident
or component failure.
With the starter switch in any position,
when this switch is pressed, all of the turn
signal lights and the turn signal indicator
lights flash to signal emergency. To turn off
the hazard lights, press the switch again.
ADVICE
Do not leave the hazard warning flasher operating for an extended time
period with the engine stopped. Otherwise, the battery may go dead, making it
impossible to restart the engine.
•
4608498sec04CONTROLSANDINSTR4-834-834608498sec04CONTROLSANDINSTR4-834-83 2015/11/0213:58:582015/11/0213:58:58
To Next Page
Loading...
