4-91
CONTROLS AND INSTRUMENTS
!"
Remote Control Mirror Switch
V
The remote control mirror switch is active
only when the starter switch is in the "ACC"
or "ON" position.
Adjustment
1. Press the left/right selector switch
on the "L" (Left) or "R" (Right) side
to move the mirror to the desired
position.
2. Press the angle adjustment switch to
adjust the mirror angle.
ADVICE
Do not try to forcefully move the
mirror surface by hand. Otherwise,
the mirror motor may sustain
damage.
•
Mirror Heater Switch
V
Defrosting the Mirror
Use the mirror heater to defrost the mirror
surface. With the starter switch in the "ON"
position, press the mirror heater switch to
turn on the mirror heater. The mirror heater
indicator light (amber) comes on. Press the
switch again to turn it to "OFF". The mirror
heater indicator light goes out.
ADVICE
Do not use the mirror heater while
the engine is not running. The mirror
heater consumes a lot of electricity
and could discharge the battery
completely.
Turn the switch to "OFF" promptly
after the mirror is defrosted.
•
•
4608498sec04CONTROLSANDINSTR4-914-914608498sec04CONTROLSANDINSTR4-914-91 2015/11/0213:59:012015/11/0213:59:01
To Next Page
