4-131
CONTROLS AND INSTRUMENTS
Should the Smoother warning light come on and remain on or flash during driving,
stop the vehicle at a safe place. If the warning light does not go out, have the vehicle
inspected at the nearest Isuzu Dealer.
If the Smoother System Fails
CAUTION
If this Smoother warning light comes on, the following conditions may occur.
Also, vehicle movement during regular operation may become abnormal, such
as difficulty during speed adjustments at very low speeds, or the inability to
pull up to loading platforms correctly. In such cases, operate the vehicle while
paying close attention to your surroundings and promptly have it inspected at
the nearest Isuzu dealer.
Creeping does not occur
Shifting up or down cannot be performed
The timing for the clutch is faster or slower than usual
In vehicles with a Smoother system, the engine cannot be started by pushing
the vehicle or turning the starter motor. If the engine stalls and cannot be
restarted, place the gearshift lever into the "N" position and make sure that the
shift indicator displays "N". Then push the vehicle to move it to a safe place.
If the shift indicator displays any position other than "N", press the Smoother
emergency switch to the "ON" position and place the gearshift lever into the "N"
position. Then push the vehicle to a safe place.
•
-
-
-
•
How to Use the Smoother Emergency
Switch
Use the Smoother emergency switch if a
failure to the Smoother system's electrical
system occurs and move the vehicle to a
safe place. After moving to a safe place,
promptly contact the nearest Isuzu dealer.
Normally, the emergency switch must be
kept in the "OFF" position. Do not touch it
during driving.
Smoother Warning Light
SA
→ Refer to page 4-49
4608498sec04CONTROLSANDINSTR4-1314-1314608498sec04CONTROLSANDINSTR4-1314-131 2015/11/0213:59:552015/11/0213:59:55
To Next Page
Loading...
