Isuzu FVM - Page 257

4-123
CONTROLS AND INSTRUMENTS
When Parking Your Vehicle
1. Set the parking brake while
depressing the brake pedal with your
right foot.
2. Place the gearshift lever into "N",
make sure that the shift indicator
displays "N", and then slowly ease
your right foot pressure off the brake
pedal.
3. Stop the engine.
Parking in Gear
When it is necessary to park your vehicle
when it is cold outside with transmission in
1st or reverse gear, follow the steps below.
1. Place the gearshift lever into the "M"
position while fully depressing the
brake pedal with your right foot, and
move the lever towards "– (downshift)"
or place the gearshift lever into
"R (reverse)". Make sure the shift
indicator displays "1" or "R".
2. Stop the engine and slowly ease your
right foot pressure off the brake pedal.
3. Make sure the vehicle does not move.
Be sure to block the wheels with
chocks.
NOTE
When starting the engine after parking it with the transmission in gear, place the
gearshift lever into "N" and depress the brake pedal while the engine is being
started. The shift indicator first displays "1" or "R" but the indication changes to
"N" after the engine is started.
After parking the vehicle with the transmission in "R", you will hear a "beep"
when moving the starter switch to the "ON" position. This is normal.
Make sure that the shift indicator displays "N" when the engine is started after
the vehicle has been parked with the transmission in gear before performing the
next operation.
•
•
4608498sec04CONTROLSANDINSTR4-1234-1234608498sec04CONTROLSANDINSTR4-1234-123 2015/11/0213:59:532015/11/0213:59:53