4-125
CONTROLS AND INSTRUMENTS
NOTE
The 1st start mode cannot be selected in the manual mode.
If the manual mode is selected (the gearshift lever is moved from "D" to "M")
after the 1st start switch is pressed, the 1st start mode is suspended and the 1st
start mode indicator light goes out.
When the mode is changed from the manual mode back to the auto mode (the
gearshift lever is moved from "M" to "D"), the 1st start mode is reestablished
and the 1st start mode indicator light comes on again but the gear position
that was selected in the manual mode is still retained. To enable automatic
gear shifting to take place, drive the vehicle and then stop it, or press the 1st
start switch again to re-select the 1st start mode, or return the transmission to
manual mode enabling the shift into 1st gear and then change back to the auto
mode.
When you place the starter switch in the "LOCK" position and restart the engine,
the transmission returns to the normal start mode (2nd start mode).
•
•
4608498sec04CONTROLSANDINSTR4-1254-1254608498sec04CONTROLSANDINSTR4-1254-125 2015/11/0213:59:542015/11/0213:59:54
To Next Page
