10
www.itec.com.pt
CB 06®v2.0
ADVANCED MECHATRONIC SOLUTIONS
contolo de acessos | control de acesso | contrôle d’accès
Power supply:
3 standrd AA alkaline batteries.
Battery life:
Average duration of one year under normal conditions.
Initialization:
Install the batteries, press S1 on circuit board. When you hear one ‘beep’, please release the S1, LED blue ashes means the operation was
successful.
Opening using a card:
Cards: Mother Card and Guest Card.
Create the mother card:
Install the batteries, press the “Reset Button” on the back panel, after a ‘beep’, touch the card which you want to become the Mother Card
lightly on the lock sensor. This card is recognized by the lock as the mother card.
Each lock can only have one mother card. The last one replaces the one before.
(Tips: the mother card can open the lock.)
Create the child card (the capacity is 15 for each lock):
Touch the mother card twice, a ‘beep’, and the LED ashes blue, then touch the card you want to become the Guest card while the blue is
ashing. One ‘beep’ means the operation was successful. (Tips: while the blue LED is ashing, you can create more child cards continuously.)
Unlock using the card: 1. use the mother card to unlock the cabinet lock.
2. use the child card to unlock the cabinet lock.
Terminate Child Card:
Touch the mother card twice, a ‘beep’ and the LED ashes blue; touch the child card which you want to delete while the blue LED is ashing.
(Tips: while the blue LED is ashing, you can delete more than one child card simultaneously.)
Terminate all Child Cards:
Touch the mother card 3 times consecutively, after the blue LED has been ashing for 10 seconds, all the information on the child card will
have been deleted from the lock.
Operate using password:
Set password:
1. Touch mother card twice, a ‘beep’ and the LED ashes blue.
2. While the blue LED is ashing, press “#”+code (1digit) +password (3-12 digits) +”#”
3. One short and long ‘beep’ means the operation was successful.
(Tips: while the blue LED is ashing, you can set more passwords: press “#”+code (1digit) +password (3-12 digits) +”#”.
There will be 4 ‘beeps’ when the password is full.)
Delete password:
Touch mother card twice, a ‘beep’ and the LED ashes blue.
While the blue LED is ashing, press “#”+code (1digit) +”#”, one ‘beep’ means that the password has been delete successfully.
(Tips: while the blue LED is ashing, you can delete others password: press “#”+code (1digit) +”#”.)
Change password:
“#”+old password + “#” + new password (3-12 digits) + “#”
Terminate the child card and password:
Touch the mother card 4 times, 3 ‘beeps’ means the operation was successful.
Unlock using a password:
input password + “#”
operations instruction
EN
EN
To Next Page
Loading...
Need help?
General