ITEM LRE 8 D10 80x80 KGT User Manual

Linear Unit LRE 8 D10 80x80 KGT
Linear Unit LRE 8 D14 80x80 KGT
Notes on Use and Installation

ITEM LRE 8 D10 80x80 KGT Specifications

General

Category	DC Drives
Power Rating	8 kW
Dimensions	80x80 mm
Type	KGT
ITEM	LRE 8 D10

Summary

General safety information

Correct use

Improper use

Operating parameters

Preparation

Installation

Shaft-Clamp Profile and Shaft D10

Instructions for assembling the shaft-clamp profile and shaft for D10 units.

Shaft-Clamp Profile and Shaft D14

Steps for assembling the shaft-clamp profile and shaft for D14 units.

Installing the Linear Unit

Detailed steps for assembling the drive nut, screw, and gimbal adapter.

Installing KGT universal bearing blocks

Tensioning the screw collet mechanism, floating bearing end

Tensioning the screw collet mechanism, fixed bearing end

Lubricating the screw

Inserting the preassembled screw into Profile 8 80x80 KGT

Installing the carriage

Adjusting Bearing Units

Procedure for preparing and adjusting the eccentric bearing units for proper alignment.

Connecting the yoke adapter to the LRF carriage

Installing the bearing block, floating bearing end

Installing the End Cap

Connecting Drive Set KGT D40/D15 - 0.0.667.76

Connecting Drive Set KGT D40/D15 SE 60 – 0.0.672.78 and Connecting Drive Set KGT D40/D15 SE 80 – 0.0.672.77

Slide Stop LRE 8

Slide Stop Configuration Notes

Details on automatic Slide Stop configuration in MotionDesigner and exceptions.

Lubrication

Maintenance