1. Charging pad
2. Holding arm
3. Holding arm control button
4. Sliding arm control button
5. Sliding arm
6. LED indicator
How to use the Itian C1 car holder
1. Installation with the suction mount
Before attaching the car holder to the windshield, dashboard or some other
smooth surface, you have to connect it to the bracket. Place the suction mount part
over the holes on the back of the bracket and pull up until it snaps into place.
After attaching the suction cup to the bracket, you can place the car holder in
the position. Make sure that the surface you're going to use is clean. Place the
suction mount and turn the knob to secure it in place. To remove the car holder, turn
the knob back and pull up the suction mount.
To Next Page
Loading...