Specifications subject to change without notice
ITOH DENKI USA, INC
135 Stewart Road rev15-0115
PH: 570-820-8811 Hanover Industrial Estates
FX: 570-820-8838 Wilkes-Barre, PA 18706-1462 Page 1 of 25
HBM-604BN/BP Technical Document
General Features
• Operates FS, FE and FP series motors
• Runs one or two Power Mollers in one or two zone configurations
o 10 pin motor connector only
• LED indications for operation and error statuses
• Automatic or manual recovery for error statuses
• Motor protection against overheating, stall condition and overspeeding
• Lead free design for RoHS conformity
• Logic for general zero pressure accumulation (ZPA) is built-in
o Singulated release
o Slug (train) release with Flexible Zone Recognition (patented)
• Direct connection for two photo-sensors for power and signal
• Easy connection between adjacent HBM-604B’s with communication cables simplifies wiring
• Independent speed control for each motor
• Adjustable timers by rotary switch
• Automatically detects the end of a conveyor line for accumulation when the communication cable is disconnected
• Stable speed function to ensure that different weight articles travel at the same rate
• Enclosure is made from fire resistant ABS