iTrainer TP-16 - User Manual

Receiver
Detects a radio signal from the wire that triggers an alert or pulse as needed.
Components - contents of the package
- Charger
-
Other items you may need
Key definitions
- Spade or pickaxe
- Mounting screws and anchors
- Wire stripping pliers
-
- Short electrodes
- Lighter
- Small screwdriver
Take a moment to read the user manual before you start installing the fence. Follow these basic guidelines
for best results:
- Auxiliary flags - 25
- Circular saw with masonry blade
- Transmitter (base)
- Scissors
- Meter
Charging the receiver
Charges the batteries inside the receiver.
Transmitter The control center of the system that transmits the radio system into the stretched wire.
IMPORTANT
It is necessary to remember that every dog has its own unique temperament. There is no way to predict how
a dog will react to this product. To ensure your dog's safety, use a long leash during initial training to
keep the situation under control. It should be noted that an aggressive animal may attack the owner when
prompted. If your dog behaves aggressively, or has ever shown aggressive behavior in the past, you
should consult a cynologist about the use of the device.
- The wire
- Non-metallic collar and leash
- USB charging cable
WARNING
- Receiver
- PVC pipe or water hose
iTrainer TP-16 manual
- Test light
More wire and flags
Pliers
and impulses.
- Drill
• Never adjust the setting while the dog is collared.
• Walk the ENTIRE plot with the receiver every time you adjust the setting!
• The collar should only be used under your supervision.
• Avoid contact of the collar with children!
• Read all instructions carefully.
• The electronic collar is designed for use on dogs.
• A low battery may cause a weaker pulse force. DO NOT use with low battery!
• Let the dog get used to the collar before you start training. The dog should not connect the collar

iTrainer TP-16 Specifications