110
GoBook Users Manual
77-0100-001 12 September 2000
.Display
The underlined, inverse, and hypertext characters are difficult to read on the screen
• Change the color scheme. From the Start Menu select Settings, Control Panel, choose Display, and then click
the Appearance tab to make changes to the color scheme.
• Make the online hypertext jumps black by adding the line JumpColor=0,0,0 to the [Windows Help] section of
WIN.INI.
I can’t see the cursor while using the DOS editor
• Press FN+INSERT to change from insert mode to overwrite mode to enable a block cursor. When it defaults
to insert mode, the DOS editor uses an underline cursor which is less visible than the block cursor for over-
write mode.
The display appears to have random pixels darkened after scrolling
• Contact your supervisor or your organization’s help desk for information about correcting this problem.
I changed my display resolution, but I see no difference on the screen
• Try restarting your computer for the changes to take effect.
To Next Page
Loading...