ITW Orbitalum ORBIMAT 165 CA - Configuring Material; Configuring Protective Gas

Operation ORBIMAT CA | Operating instructions
30
orbitalum tools GmbH, D-78224 Singen, www.orbitalum.com, Tel. +49 (0) 77 31 792-0 (09.03.15) OW_ORBIMAT_CA_BA_871060202_04_EN
2. Select desired weld head by turning the rotary knob.
– or –
Select the weld head highlighted by the system.
3. Confirm by briefly pressing the rotary knob.
8.1.3 Configuring material
X Select "Material" field and briefly press the rotary knob.
The following display appears:
Materials in the list:
• Chrome-nickel-steels: Five materials
• Ferritic materials: Two materials
• Titanium (Ti)
Fig. 11: Selecting material
Does the material used not appear in the list?
X Select the most similar material (example: for stainless steels, one of the chrome-nickel-steels).
1. Select material.
2. Confirm by briefly pressing the rotary knob.
8.1.4 Configuring protective gas
1. Select "Gas type" field and briefly press the rotary knob.
2. Select protective gas.
3. Confirm by briefly pressing the rotary knob.