Operation ORBIMAT CA | Operating instructions
56
orbitalum tools GmbH, D-78224 Singen, www.orbitalum.com, Tel. +49 (0) 77 31 792-0 (09.03.15) OW_ORBIMAT_CA_BA_871060202_04_EN
8.10.3 Working with external memory cards
Supported storage media:
• CF cards
• SD cards
• MMC cards
• Smart Media cards
• Sony Memory Sticks
X Ensure that the memory card has "FAT formatting".
Available functions:
• Saving and reading procedures
• Saving of logs and procedures for further processing externally with special external software (OrbiProg CA)
• Backing up, restoring and updating system data. This system data is essentially the operating software itself, the
library of the available weld heads, the auto programming database and the various operating languages of the
software.
Inserting external memory card
X Push card into the appropriate slot of the card reader.
A diskette symbol appears in the bottom right-hand corner of the display.
Is there no diskette symbol?
1. Remove memory card from the slot.
2. Disengage card reader using the ejector, remove it from the housing and insert it again.
3. Insert memory card into the slot again.
Using external memory card
Use depends on the software version.
Machines supplied before May 2008 (software version lower than 0.2.00):
The external memory card must be "activated".
1. In the main menu, select "System settings" > "Program settings".
2. Select the "External card" option in the "Procedure space" field.
The diskette symbol at the bottom right appears red. The memory card is activated as the storage medium.
When writing and reading, the software no longer uses the internal memory, but will use the external memory card
instead.
Machines supplied after May 2008 (software version from 0.2.00 onwards):
An external memory card is detected automatically (diskette symbol visible in the display).
The selection between internal and external memory is offered for all functions.
Write/read logs to/from memory cards:
Logs are always saved on the external memory card, as they are generally only used externally, e.g. on a PC with the
"OrbiProgCA" program.
To Next Page
Loading...