Service and troubleshooting ORBIMAT CA | Operating instructions
66
orbitalum tools GmbH, D-78224 Singen, www.orbitalum.com, Tel. +49 (0) 77 31 792-0 (09.03.15) OW_ORBIMAT_CA_BA_871060202_04_EN
9.1.5 Printing a test page
X Press "Print test page" button.
A test page with a mixed character set is output on the printer which has been activated (internal or external).
9.1.6 Service Screen
View current status of all digital or analog input and output signals of the control computer.
• Digital In: Current values of the digital inputs of the computer
• Digital Out: Current values of the digital outputs of the computer
• Analog In: Current values of the analog inputs of the computer
• Analog Out: Current values of the analog outputs of the computer
• Inverter: Status of the serial interface used for communication between computer and power source (RS232)
• Actual Val: Display of the current actual value of the running process calculated from the information of the analog
inputs or serial inverter interface
1. Press "Service Screen" button.
The following display appears:
2. Press "Service Screen" button again.
The graphical view of the current weld procedure appears
in the display.
Displaying Service screen during a running welding
process
X Enter letter sequence SER (for SERVICE) on the external
keyboard.
The Service screen on the running welding process ap-
pears in the display.
Fig. 36: Service Screen
9.1.7 Info
Information on the currently used software version and Serial No. of the machine.
View Info
X Enter letter sequence VER (for VERSION) on the keyboard.
To Next Page
Loading...