iVAC Pro Remote User Guide P7 and 8
Tool Address
Each iVAC Pro Remote or iVAC Pro Tool must be assigned
an independent one of eight tool address. This information is
used by the Switch to enable it to know the status of each
individual iVAC Pro Tool or iVAC Pro Remote in the
System. The Tool Address is set by means of positions S3,
S4 and S5 of the Program Switch.
iVAC Pro Remote User Guide Pages 9 and 10
Replacing the batteries
The batteries have a useful life of 25,000 operations over a
3 year period.
To remove the batteries it is recommended to use the tip of
a pen or similar device and push from the inside edge of the
battery holder.
When replacing batteries, both batteries should be replaced
at the same time. The positive (+) side of the battery should
face away from the circuit board.
Specifications
Plastic housing ABS 94V0 plastic.
Powered by 2 CR2032 lithium batteries.
Rf Range 40’ line of sight.
Regulatory approval
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions
(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by
the party responsible for compliance could void the users
authority to operate the equipment.
FCC ID: YCHIVACPRO IC 8940A-IVACPRO
Tool Address
* factory setting
S3 S4 S5
1 On Off Off
2 Off On Off
3 On On Off
4 Off Off On
5 On Off On
6 Off On On
* 7 On On On
8 Off Off Off
To Previous Page
Loading...
