13
USAGE
Automatic Defrosting
If the air conditioner detects frost buildup, the unit will automatically defrost.
Defrosting is indicating by a heating symbol flashing on the LCD screen.
Automatic Thermal Protection
Should the air conditioner become too hot, the unit will enter automatic
thermal protection. When in this protection, the compressor and lower
motor will stop operating until the unit cools down. Once the air conditioner
is within operating temperatures again, normal operation will resume.
Compressor Protection
To extend the life of your compressor, the compressor will power on after a
three (3) minute delay when the unit is turned o and on again.
DRAINAGE INSTRUCTIONS
Manual Drainage
• Before manually draining your air conditioner, power o and unplug the
unit.
NOTE: Move the air conditioner carefully to prevent spills.
• Align the water plug with the receptacle you plan to drain the water into.
• Unscrew the water plug and let the water drain out naturally.
NOTES: To ensure complete draining, tip the air conditioner back slightly.
If the receptacle you are draining water into is not large enough, simply
reinsert the water plug to stop draining.
• With the unit drained, reinsert the water plug and tighten the drainage
cover. Make sure each is properly set before restarting the unit.
NOTE: Restart the air conditioner after the water plug and drain cover are
reinstalled to prevent condensation from dripping onto the floor.
Continuous Drainage
• Unscrew the drainage cover and remove the water plug.
• Insert the drainage hose into the water outlet.
• Run the drainage hose to a receptacle.
USAGE
To Next Page
Loading...
