How to Operate
IMPORTANT: READ ALL OPERATING INSTRUCTIONS PRIOR TO FIRST USE.
IMPORTANT: DISCONNECT THE POWER CABLE WHENEVER ENGINE IS TURNED OFF FOR
EXTENDED PERIODS OF TIME. THE POWER DOES NOT TURN OFF AFTER SWITCHING OFF
THE ENGINE IN SOME CARS. IF THE POWER PLUG IS LEFT CONNECTED, THE BATTERY
MAY BECOME RUN DOWN OR SUSTAIN DAMAGE.
Plug into car cigarette lighter/charger (Diagram 1)
NOTE: Some vehicles require that ignition be in accessory position.
PURGE AIR FROM SYSTEM: To purge air, turn unit on (Diagram 2). Point nozzle into water
tank and squeeze lever until steady stream of water exits hose (Diagram 3).
With normal use, air can get trapped in the hose. We recommend the following steps to purge
the air from your system and get the maximum pressure out of your car washer.
FOLLOW THESE STEPS AFTER EACH TIME YOU REFILL YOUR TANK:
1. Fill the tank with water.
2. Connect the hose to the unit.
3. Connect the power cord to the unit.
4. Direct the hose. Without the nozzle attached, into the tank.
5. Turn the power on and run for approximately 30 seconds or until a steady stream of
water is present.
6. Turn off the power.
7. Connect the nozzle to the hose.
NOTE: Start the car while using the device if you are not sure if the capacity of the battery
is sufficient.
7
Diagram 1 Diagram 2 Diagram 3
To Next Page
Loading...