Iveco Motors Cursor 13 Series User Manual

12
Engine stop
Before stopping the engine it is recommended to keep it running at
idle and unloaded for few minutes; this will allow for a uniform
reduction of temperature and avoid harmful thermal shocks.
A. To stop the engine from IVECO MOTORS main panel, turn the
key switch to the stop position 8A or act on any similar control if
your boat is equipped with a customized dashboard.
B. To stop the IVECO MOTORS secondary panel press the red push
button (6) located on it.
To stop the IVECO MOTORS main panel for the engines equipped
with "in eccitazione" device (available upon request or prescribed by
certification authorities), press the red push button(9).
To restart the engine from the main panel:
1. Turn the key switch to the stop position 8A to reset any panel
operation enabled.
2. Proceed as shown.
To restart the engine from the secondary panel:
1. Make sure the panel is enabled (key switch on the main panel
turned to 8B).
2. Press the green push button (5) and release it when it has started,
making sure that the revolution indicator reading is acceptable.

Iveco Motors Cursor 13 Series Specifications

General

Brand	Iveco Motors
Model	Cursor 13 Series
Category	Engine
Language	English