25
ENGLISH
INSPECTIONS AND MAINTENANCE
MAINTENANCE STAFF
Engine inspection and maintenance interventions described in the
following section require training, skills and the observance of the
safety regulations provided. Therefore only spacialized staff can
perform them as specified below.
Inspections: shop operators or boat user if necessary.
Periodical maintenance: qualified staff, equipped
with suitable tools and protection gear. Interventions
marked with a wrench (see picture).
Extraordinary maintenance: Authorized Servicing
Centers' qualified staff having the specific technical
know-how and equipment. Interventions marked with
a wrench (see picture).
Authorized Servicing Centers are members of IVECO MOTORS
Customer Care Network.
ACCIDENT PREVENTION
Always wear safety shoes and gear.
Do not wear loose garments, rings, bracelets and/or necklaces near
the engines or moving parts.
Wear safety gloves and goggles when:
• refilling batteries with acid solution
• refueling with inibitors or deicers
• replacement or refueling of lubricant (hot engine oil can cause
burns. Proceed with interventions only when it has reached a
temperature lower than 50°C).
When performing interventions inside the engine housing, use
utmost care when moving in order to avoid contact with rotating
or high temperature items.
Wear safety goggles when using compressed air (the maximum
cleaning air pressure is 00 kPa (2 bar, 30 psi, 2 kg/cm
2
).
Wear a hard safety hat if you work in an area with suspended loads.
Use protective hand cream.
Immediately replace wet overalls.
Keep the engine always clean and eliminate oil, diesel and coolant
stains.
Place greasy rags in fireproof containers.
Do not leave foreign bodies on the engine.
Use suitable and safety container for exhaust oil.
When the repair is finished, take the necessary steps to stop engine
air suction in case, after start-up, an unrestrained increase of engine
revolution occurs.
To Next Page
Loading...
Need help?
General
