Iveco Motors Cursor 13 Series User Manual

40
LONG ENGINE INACTIVITY
ENGINE PREPARATION FOR LONG INACTIVITY
PERIODS
In case of prolonged inactivity and order to avoid oxidation of internal
parts of the engine and of some components of the injection system,
prepare the engine as follows:
1. Drain the lubricant oil from the pan, after warming up the engine.
2. Fill with 30/M protective oil (or an oil compliant with MIL 2160B
type 2 specifications) until "minimum" level is reached on the dip
stick. Start the engine and keep it running for 5 minutes.
3. Bleed the fuel from the injection circuit, the filter and from the
injection pump piping.
4. Connect the fuel circuit to a tank containing protective liquid CFB
(ISO 4113) and run the engine for 2 minutes after cutting out the
injection system. This can be done by energizing terminal 50 on the
starter with positive voltage equal to the system rate voltage, using
a conductor.
5. Spray approximatively 80 g of protective oil 30/M (10 g per liter of
swept volume) on the supercharger suction intake, during the
above motoring.
6. Close with plugs or seal any opening.
7. Drain any residual 30/M oil. Store for future use (enough for 2
preparations).
8. Apply ENGINE WITH NO OIL labels to the engine and on board
panel.
9. Drain coolant, and place a label stating the operation has been
completed.
In case of extended inactivity, repeat the above every 6 month, as
follows:
A) Drain from 30/M protective oil;
B) Repeat from step 2.
In case protection of engine external parts is required, spray all
unpainted surfaces with OVER 19 AR protection liquid, avoiding belts,
cable connections and electric parts.

Iveco Motors Cursor 13 Series Specifications

General

Brand	Iveco Motors
Model	Cursor 13 Series
Category	Engine
Language	English