41
ENGLISH
COMMISSIONING AFTER AN EXTENDED
PERIOD OF INACTIVITY
1. Drain any residual 30/M protective oil.
2. Fill the engine with lubricating oil as provided in REFUELLING table.
3. Drain any protective liquid from the fuel circuit and follow the
instructions provided in point 3
ENGINE PREPARATION FOR
LONG INACTIVITY PERIODS.
4. Remove any closing and/or sealant. Connect the supercharger
intake to the air filter.
5. Connect fuel circuits to the boat tank and follow the instructions
provided in point 4 in ENGINE PREPARATION FOR LONG
INACTIVITY PERIODS.
6. Check and refill the engine with coolant, as instructed.
7. Start the engine and keep it running until idle speed is stable.
8. Check that readings are acceptable and that no alarm is on.
9. Stop the engine.
10.Remove ENGINE WITH NO OIL labels from the engine and on
board panel.
FIRST START-UP AFTER LONG INACTIVITY
PERIODS
1. Refill the engine as provided in REFUELLING table.
2. Remove the sacrificial anode (1) and fill with 1.5 liters of water, in
order to start the sea water pump.
3. Place the anode back into its housing and tighten as provided.
4. Degas the cooling circuit as follows:
Keep the engine running at idle speed, carefully loosen the screw
(2) and screws (3) located on the coolant pan and on the drain
manifold respectively. Tighten and stop the engine. Check coolant
level, refill if necessary. Do not disperse in the environment any
liquid.
2
1
3
05_001_C
To Next Page
Loading...
Need help?
General
