Iwata NEO BCN - Quick Start Guide; Begin Airbrush Setup; Loading Paint; Starting Airbrushing

Push down and pull back on the trigger. (Push down for air ow, push
down and pull back for paint ow.) As you push down and pull back on
the trigger, move your airbrush around – keep moving!
For ner lines, turn the air pressure down then push down and pull
back on trigger just a little... keep moving your airbrush!
To clean your airbrush, ush it out with the appropriate cleaner for your
medium (such as airbrush cleaner) or use water (good for water-based
mediums) and spray airbrush until it sprays clear.
ANEST IWATA-MEDEA, Inc.
1336 N. Mason St. Portland, OR 97217
503-253-7308 | www.iwata-medea.com
Begin by attaching your airbrush
hose (Iwata hose sold separately)
to your NEO airbrush.
Make sure the other end of your
airbrush hose is attached
to your air source (compressor
sold separately).
For the gravity-feed NEO, put a small amount of paint into the color cup
on top of the airbrush (note you have 2 choices of cup size). The airbrush
will also hold 1/32 oz. of paint without a cup attached.
For the siphon-feed NEO, put paint into the Big Mouth Bottle (included)
and attach the bottle to the bottom of the airbrush by pushing it into
the airbrush. (Bottle does not screw in.)
Turn your compressor on.
For further in-depth tips and info, please go to
www.iwata-neo.com
BEGIN
CLEANING
1
PAINT
2
START AIRBRUSHING
3
TO AIR SOURCE
GRAVITY-FEED NEO
SIPHON-FEED NEO
BIG MOUTH BOTTLE
For further in-depth tips and info, please go to
www.iwata-neo.com
Quick Start Guide
Push down and pull back on the trigger. (Push down for air ow, push
down and pull back for paint ow.) As you push down and pull back on
the trigger, move your airbrush around – keep moving!
For ner lines, turn the air pressure down then push down and pull
back on trigger just a little... keep moving your airbrush!
To clean your airbrush, ush it out with the appropriate cleaner for your
medium (such as airbrush cleaner) or use water (good for water-based
mediums) and spray airbrush until it sprays clear.
ANEST IWATA-MEDEA, Inc.
1336 N. Mason St. Portland, OR 97217
503-253-7308 | www.iwata-medea.com
Begin by attaching your airbrush
hose (Iwata hose sold separately)
to your NEO airbrush.
Make sure the other end of your
airbrush hose is attached
to your air source (compressor
sold separately).
For the gravity-feed NEO, put a small amount of paint into the color cup
on top of the airbrush (note you have 2 choices of cup size). The airbrush
will also hold 1/32 oz. of paint without a cup attached.
For the siphon-feed NEO, put paint into the Big Mouth Bottle (included)
and attach the bottle to the bottom of the airbrush by pushing it into
the airbrush. (Bottle does not screw in.)
Turn your compressor on.
For further in-depth tips and info, please go to
www.iwata-neo.com
BEGIN
CLEANING
1
PAINT
2
START AIRBRUSHING
3
TO AIR SOURCE
GRAVITY-FEED NEO
SIPHON-FEED NEO
BIG MOUTH BOTTLE
For further in-depth tips and info, please go to
www.iwata-neo.com
Quick Start Guide
QUICK START GUIDE INCLUDED WITH YOUR AIRBRUSH
2