— 14 —
PILOT'S WATCH MARK XVIII
REMOVING INDIVIDUAL LINKS
AND ATTACHING THE BRACELET
Repeat steps 1 to 3 at the distance from the first point of separ-
ation you have just determined.
Remove the unnecessary links and reassemble the shortened
bracelet. When reassembling the central link, make sure that the
outside is still facing downwards.
Reinsert the external link with both the pivot pins, which was
removed at the beginning, back into the bracelet (4). Now you
can slide the opposing external bracelet link back into the brace-
let until it lies flush, by simultaneously pressing down its securing
pin (5).
To finish, check that the securing pins are sitting correctly (6).
These must be brought up flush with the upper edge of the
external links.
Keep the surplus links and separating tool in a safe place for use
in any adjustment at another time.
To Next Page
Loading...
