5. Plug in. A “beep” will be heard and all the lights on the control panel (1) will turn on briefly. Then
a "beep" will be heard and the light of the power button (15) will remain on.
6. Press the power button (15). A sound will be heard, all the indication lights will turn on and the
display (10) will alternate “180
o
C” and “15min”.
Note: If you do not press any key for 20 seconds, the lights will turn off and the appliance will enter
the standby mode and the power indication (15) will remain on.
7. Press the time selection button “ ” (17) to set 5 minutes.
8. Press the start/pause button (16) and the appliance will start.
9. All the indications on the control panel will turn on. The function indication (9) and the fan
operation indication (11) will turn on and on the display screen (10) the selected time (5min)
and the preset temperature (180
ο
C) will alternate.
10. When the selected program is finished, the display screen (10) will show “OFF”, the fan
operation indication (11) and the power button (15) will remain on.
11. After 20 seconds a sound will be heard 5 times and the appliance will stop. On the control panel
(1) all the lights will turn off and the power button (15) will remain on.
12. The appliance is ready for use.
• Make sure the appliance is switched off and unplugged before use.
• Make sure you have attached the handle to the bucket.
• It is recommended to preheat the appliance for 5 minutes without food before cooking.
1. Wash the parts of the appliance. See "Care and Cleaning" section.
2. Place the appliance on a clean, flat and heat-resistant surface.
3. Place the rack (7) in the bucket (2). See “Inserting detachable rack” section.
Note: Do not use the appliance without the detachable rack.
4. Place the food on the rack (7) and insert the bucket (2) in the reception until it snaps into place.
Note: Make sure the food in the bucket does not come into contact with the heating resistant.
Note: If the bucket with the rack do not fit well into the airfryer cavity, the appliance will not turn on.
5. Plug in. A “beep” will be heard and all the lights on the control panel (1) will turn on briefly. Then
a "beep" will be heard and the light of the power button (15) will remain on.
6. Press the power button (15). A sound will be heard, all the indication lights will turn on and the
display (10) will alternate “180
o
C” and “15min”.
Note: If you do not press any key for 20 seconds, the lights will turn off and the appliance will enter
the standby mode and the power indication (15) will remain on.
7. Press the icon of the program you want (see section "Table of programs & preset times &
temperatures"). The corresponding light (14) will flash and the preset temperature and time will
alternate on the display screen (10).
8. Press the temperature setting buttons (12) consequently to set the temperature of your choice.
9. Press the time setting buttons (17) consequently to set the time of your choice.
10. Press the start/pause button (16) and the program will start. The indication light of the of
the selected program will flash, the function indication (9) and the fan operation indication
(11) will turn on and on the display screen (10) the selected temperature and time will alternate.
Note: To activate the interior light, press the light function button (13). The corresponding lamp
To Next Page
Loading...