To Next PageTo Next Page
Need help?Do you have a question about the J. Perkins Twister 3D Storm and is the answer not in the manual?
General| Brand | J. Perkins |
|---|---|
| Model | Twister 3D Storm |
| Category | Toy |
| Language | English |
Details the design and capabilities of the Twister 3D Storm helicopter.
Advises new pilots to start with simpler models before this advanced helicopter.
Highlights critical safety precautions for operating the helicopter.
Explains that the helicopter comes mostly assembled with key components pre-installed.
Informs users about the availability of spare parts through local retailers.
Lists essential additional equipment needed to prepare the helicopter for flight.
Instructions for carefully unpacking the model and inspecting for damage.
Steps to ensure the tail gearbox is perpendicular and the horizontal fin is aligned.
Guidance on tightening the tail rotor blades securely.
Instructions for attaching the undercarriage and tail boom support.
Steps for fitting the main rotor blades using bolts and nuts.
Procedure for installing the receiver and securing it with double-sided tape.
Guidance on mounting the ESC and connecting it to the motor.
Provides recommended pitch settings for Normal and 3D flight modes.
Lists factory pushrod lengths for reference during setup and repair.
Essential checks for linkages, nuts, and bolts to ensure secure operation.
Instructions for connecting the AC power adapter or 12VDC lead to the charger.
Steps for connecting the Li-Po battery balance plug to the charger.
Guide on sliding the battery into the cavity and securing it with the Velcro strap.
Lists various spare parts with their part numbers for ordering.
Details optional parts available for the Twister 3D Storm helicopter.
A detailed visual breakdown of all helicopter components with reference numbers.
Defines channel assignments for servos, speed control, and gyro.
Specifies end point adjustments for various channels.
Configuration for reversing servo direction on specific channels.
Settings for fine-tuning servo neutral positions.
Mixer settings for Aileron, Elevator, and Pitch control.
Settings for high and low rates for Aileron, Elevator, and Rudder.
Defines throttle curve points for Normal and Stunt modes.
Defines pitch curve points for Normal and Stunt modes.
Defines channel assignments for servos, speed control, and gyro.
Specifies end point adjustments for various channels.
Configuration for reversing servo direction on specific channels.
Settings for fine-tuning servo neutral positions.
Mixer settings for Aileron, Elevator, and Pitch control.
Settings for high and low rates for Aileron, Elevator, and Rudder.
Defines throttle curve points for Normal and Stunt modes.
Defines pitch curve points for Normal and Stunt modes.
Defines channel assignments for speed control, servos, and gyro.
Specifies end point adjustments for various channels.
Configuration for reversing servo direction on specific channels.
Settings for fine-tuning servo neutral positions.
Mixer settings for Aileron, Elevator, and Pitch control.
Settings for high and low rates for Aileron, Elevator, and Rudder.
Defines throttle curve points for Normal and Stunt modes.
Defines pitch curve points for Normal and Stunt modes.
