Jabra Elite 4 Active - Black
How do I pair my Jabra Elite 4 Active with my mobile device?
To pair your headset with your mobile device or tablet, follow these steps.
1. Turn on the Bluetooth setting on your mobile device.
2. Turn on your earbuds by removing them from the charging case.
Alternatively, press the Left and Right buttons.
The LEDs on both earbuds will turn green.
3. To enter pairing mode, simultaneously press and hold (3 seconds) the
Left and Right buttons on the earbuds, until the LEDs on the earbuds
flash blue.
The earbuds are now ready to pair with your mobile device.
Note
If you want to use just one earbud, you must still pair both earbuds
with your mobile device. After the pairing, you can place one of the
earbuds in the charging case.
4. To pair, go to the Bluetooth menu on your mobile device and select the
Jabra Elite earbuds from the list. Enter “0000” (four zeros) if you are
asked for a pin code.
In daily use, when you turn on the earbuds, they will automatically
reconnect with the last previously paired device, if it is turned on and
within range.
Note
To Next Page
Need help?
General
Weight and Dimensions
