Maintenance manual for sunray hfc4da1-2c china-IV diesel engines
196
33.
DTC P2299 Depress accelerator pedal and brake pedal at the same time.
Fault Description: Accelerator pedal assembly consists of two accelerator pedal position (APP) sensors. Accelerator
pedal position sensors are installed on pedal assembly and they are not maintainable. When driver depresses
accelerator pedal, air inflow of cylinder is increased and ECU increases fuel injector pulse width in order to supply
additional fuel during acceleration process for engine demand. Brake switch is a normally open one. When brake
pedal is depressed, this switch is closed in order to provide TCU with voltage for brake application. In the case of
misoperation of driver during driving, brake system will be locked after depressing brake pedal and brake pedal can
not return to its original position. Under such condition, depressing accelerator pedal will lead to DTC occurrence due
to conflict between acceleration and brake signals in the case of engine braking status. In addition, improper
maintenance or ECU control circuit failures will lead to such faults.
Diagnosis Hint: Check brake system and acceleration system for stuck pedal position without pedal returns. Check
the circuit between ECU and components for good contact of connection and good harness insulating property. For
connection test for ECU and components, diagnostic connectors should be applied.
To Next Page
Loading...