JACUZZI COMET CLEANER
// Troubleshooting Guide
For Additional Assistance
Call Jacuzzi Support
1-844-615-8994
Symptom Possible Reason Corrective Action
Cleaning Performance
Cleaner is not picking up dirt/debris Filter is clogged Rinse filter
Cleaner picks up dirt, then scatters
debris across pool
Cover is not fastened onto the body
properly, allowing debris to re-enter the
water and/or when the cleaner is lifted
out of water
Ensure cover is fastened onto the body
before use, and lift cleaner carefully out
of water after use
Nozzle Settings
Nozzles are difficult to adjust
Nozzle is damaged or installed
improperly
Replace or reset nozzle
What nozzle settings are best for my
pool?
See Corrective Action
1. Default nozzle settings applies
to most pools
2. Increase the angle if cleaner
does not cover entire pool
3. Decrease angle if cord begins to
tangle
Refer to Owner’s Manual for additional
nozzle recommendations
To Previous Page
Loading...
Need help?
General
