77
CAUTION: If freezing conditions exist and pump is not opera-
tional, take measures to protect the system from possible damage
from freezing. See “Winterizing”.
POOR JET ACTION.
- Make certain the jets pump is turned on.
- Check position of massage selectors.
- Open air control for selected jet system.
- Check for adequate water level.
- Check for dirty filter
WATER IS TOO HOT.
- Reduce thermostat setting.
- Switch hot tub to “Econo” mode to turn heater on only during
pre-programmed time.
- Make sure the pumps are turned off and not constantly run-
ning.
NO HEAT
- Check thermostat setting.
- Keep the cover in place while heating.
- If heater indicator is displayed, but no temperature increase
is experienced after a reasonable period of time, contact your
dealer or authorized service center.
FILTER/CIRCULATION PUMP OFF
- Check that the recirculation pump has been programmed
correctly.
- Make sure there are no errors preventing the pump from
turning on.
- The hot tub water is hotter than 34°C (95°F) and 1°C more
than the set temperature. The “Summer Logic” safety feature
has been activated (see the relevant section).
To Next Page
Loading...
Need help?
General
