76
J-400
22. ProClarity/ProClear Filter Reminder: This message
will appear when the lter reminder time has expired
(Figure 15.0d). Remove the ProClarity/Proclear lters
and lter/debris bag for cleaning or replacement.
23. ProClarity Depth Filter Reminder: This message will
appear when the lter reminder time has expired
(Figure 15.0e). The ProClarity Depth lter must be
replaced.
24. Water Refresh Reminder: This message will
appear when the “Water Refresh” timer has expired
(Figure 15.0f). The water needs to be drained and
relled with fresh water.
25. Extended Temperature Activated: The spa is set
to go up to 104°F (40°C), but it can be set to reach 106°F (41°C).
To access the extended temperature you need press and hold
your nger over the temperature reading for about 5 seconds. The
temperature reading will start to blink to indicate the system is ready.
Tap to raise the temperature up to 106°F (41°C).
Note: The heater icon will be blinking to indicate that the feature is
active.
WARNING: RISK OF HYPERTHERMIA (OVER-HEATING)
CAUSING SEVERE INJURY, BURNS, WELTS OR DEATH!
Water temperature in excess of 104°F (40°C) may be injuri-
ous to your health.
!
Reminder
It’s time to clean or replace
your ProClarity and Pro-
Clear filters. Contact your
authorized dealer if new
filters are needed.
snoozereset
Figure 15.0d
Reminder
It’s time to replace your
ProClarity Depth filter.
Contact your authorized
dealer for a new filter.
snoozereset
Figure 15.0e
Reminder
This is a general
reminder. Please change
your water soon.
snoozereset
Figure 15.0f
To Next Page
Loading...
