29
The Sanitization cycle does not activate
- The water level is too low (consult the information provided
relative to hydromassage.
The Sanitization cycle stops of its own accord
- The water has fallen below the minimum level (e.g. drain open);
the spotlight ashes red.
Restore the water level within 5 minutes from notication (the
pump will activate and the cycle continues); where this is not com-
pleted, the cycle is denitely interrupted.
The display does not receive commands
- If two keys are accidentally pressed at the same time, no func-
tion is activated.
You will need to wait three seconds before giving a new command
- If the display is covered by a layer of water, it may not receive
commands.
Just wipe the water o with the palm of your hand and wait about
3 seconds before giving another command.
Maintenance
ATTENTION! Before carrying out any maintenance op-
eration, disconnect the appliance from the power sup-
ply line.
Cleaning the air outlets
Remove any residue and wash the various components with wa-
ter and soap.
Cleaning the hydromassage outlets
Proceed as described above.
1
2
Cleaning the tub and the taps and ttings
It is simply sucient to dry the various components; should you
need to carry out a more thorough cleaning procedure, elimi-
nate any stains using a cloth dampened with soapy water or
neutral detergent; rinse with fresh water and dry.
Do not use abrasive towels, powdered detergents, ac-
etone or other solvents.
The tub may be periodically bued using polish: contact a Jacuz-
zi® Support Centre, even in the case of scratches or surface dam-
age.
Cleaning the headrest
Use a cloth or a soft brush and soap.
To Next Page
Loading...
