Jacuzzi Profile

31
XOpen the drain valveand completely empty the hot tub.
ø 40mm
1½”
1
3
2
4
CAUTION

Do not use the hot tub the rst time you start it as there
is a high concentration of chlorine in the water during
this phase. Immediately empty the bath.
Contact the local authorities for the standards govern-
ing the discharge of chemically treated water.
XClose the drain valve(s) and ll the hot tub again with fresh
water as previously explained.
XTurn the omnipolar switch back on and check that the hot
tub works correctly.
XProceed with the chosen water treatment.

WARNING: read and follow all the instructions related
to the use and storage of chemical products, adhering
strictly to the manufacturer’s instructions on the pack-
aging.

WARNING! Do not use trichlorine tablets! This may
damage the hot tub components and cause burning or
irritation to the skin and mucous membranes. Any use
of these chemicals voids the manufacturer's warranty.
XCheck and as necessary modify the water ltering cycles
based on how you intend to use the hot tub.
Installation of front and side panels
(where included)
XRefer to the corresponding drawings. ( 3).
Cover
XInstall the locking system of the cover ( 4).
Control panel and functions

CAUTION
Only modify the parameters indicated: do not change
the conguration of the other parameters.
(
 5) All hot tub functions are managed via the control panels on
the tub, as are the respective settings/programming.
NOTE Up/Down button : hold down the key to increase;
once the key is released, the direction will reverse (when pressing
the key, the display value will decrease) and so on.
A1 A2
B
A1
2
1
A2
5

ltering LED
heater LED
Temperature adjustment LED
viewing and adjusting temperature,
parameters, functions
spotlight
pump
blower
blower LED
Prole Base
Prole TOP Prole TOP