16. LED indicator
Light color
Green
Flashing Green
Flashing Red
(every 2 seconds)
Flashing Red
(2 times per second)
17. Safety tips
Description
Normal operation
Printer Head is
overheated
1. Paper shortage
2.Wrong size paper
Printer cover is not
fully closed
See FAQ at support.jadens.com
Troubleshoot
Printer will automatically
resume once the printer
head has cooled down.
Be sure that the labels are
loaded correctly. You may
need to run automatic label
identification(point5at page34),
Check that the printer
cover is completely closed.
- The printer head can become very hot after printing labels. Do not touch the printer head until
it has cooled.
- Do not bend the power cord excessively or place objects on the cord.
This could result in fire.
- Keep the printer out of reach of children.
- Use only approved accessoriesand do not try to disassemble or repair the unit by yourself.
Keepthe printer away from water and other objects that may destroy or damage the device.
- Printer should remain unplugged when not in use for long periods of time.
18. Maintenance
CLEANING THE PRINT HEAD
The printer head is a sensitive part of the printer and can be found on the upper part of the printer
when open.
Caution: While the printer is running, the printer head can be very hot.
1. Ensure that the power switch is OFF, remove the power cord, and open the cover. Wait several
moments to ensure that the printerhead cools down.
2. Completely clean the printer head using an alcohol swab. Any 70% Isopropyl Alcohol pad would
work. Please do not use water.
3. Wait 2-3 minutes until the alcohol has completely dried, then close the cover.
4. Connect the power cord and print a test page to check if it is clean.
22
To Next Page
Loading...