EasyManuals Logo

Jadever JIF-2002 User Manual

Jadever JIF-2002
67 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
JIF-2002 WEIGHING INDICATOR&CONTROLLER
6
2-1 Best Conditions For Use
When installing and wire connecting on JIF-2002, please follow the
points and guide for preventing any abnormal situation occurred.
Before connecting the Electric Power Supply, please identify
the input Electric voltage type is AC 110V or AC 220V.
The Grounding Wire shall be properly connected .
The Operation Temperature shall range within 0 ~ 45 ,
please DO not install in any place of direct sun-light.
Due to the minute output signal from Load Cell, please use
isolated cables. Also, separate the Load Cell cable from the
power supply cable and control I/O cables.
The input power shall be AC 110V or AC 220V±10%, if the
Electric Power Supply is not stable or the interference signal
exists, that may cause uncertain actuation or reaction, even
damages .
Therefore, please utilize Electric Power Supply Stabilizer of
adequate capacity.
2-2 Power Supply Connecting
Open the case, there is a jumperS1near the transformer, please insert
a short-circuit pin to the available side.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jadever JIF-2002 and is the answer not in the manual?

Jadever JIF-2002 Specifications

General IconGeneral
BrandJadever
ModelJIF-2002
CategoryController
LanguageEnglish