29
SETTING THE ALARM
Winding
Crown A in position 0.
The alarm is wound by turning the crown
clockwise. When winding is complete, the
crown is locked.
Setting the alarm time
Pull Crown A out to position 1.
This function enables you to adjust the alarm’s
mobile disc by turning the crown anti-clockwise
to position the triangular mark situated in the
centre of the dial opposite the desired alarm time.
Once the operation is complete, push Crown A
back into position 0.
Starting and stopping the alarm
The alarm is activated when Crown A is in
position 0. It is stopped when the crown is in
position 1.
The chime can be stopped at any time by
pulling out Crown A. However, note that the
crown must be pushed back into position 0 to
ensure water resistance.
ENGLISH
To Next Page
Loading...
