Need help?Do you have a question about the J&M Corporation JAMP-500HC06-SGR and is the answer not in the manual?
General| Power Output | 500W |
|---|---|
| Channels | 6 |
| Frequency Response | 20Hz - 20kHz |
| Signal-to-Noise Ratio | >90dB |
| Type | Class D |
| THD | <0.1% |
| Cooling | Fan-cooled |
| Impedance | 4 Ohms |
Remove outer fairing shell, seat, and fuel tank for access.
Route the amplifier power harness from the fairing to the battery.
Route the rear speaker wiring harness to the rear speaker mounting location.
Connect the amplifier power harness positive lead to the battery positive post.
Remove CB/SAT radio modules from the factory radio for installation.
Remove forward radio mounting bolts and loosen rearward mounting bolts.
Relocate large plugs from inside fairing braces to the outside.
Remove rubber grommets from the top of the factory radio.
Remove metal stud from the right side fairing brace with a cutting tool.
Cut 1/2" material from bottom of gauge cups for amplifier clearance.
Position the J&M Amp/Bracket assembly above the radio and slide into position.
Replace forward radio mounting bolts and tighten all mounting bolts.
Make amplifier and speaker connections according to the diagram.
Install removed CB/SAT radio modules into the lower mounting bracket.
Position lower bracket assembly below the factory radio and secure with screws.
Reconnect the CB/SAT radio harness and antenna connectors.
Test the system for proper operation before reassembling the fairing.
To Next Page