Janome 1600P - Replacing the External Parts; Face Plate; Top Cover; Belt Cover

1
Replacing the External Parts
1. Face Plate
2. Top Cover
3. Belt Cover
4. Motor Cover
5. Base
Remove the setscrew (1) and washer (2). Re-
move the face plate (3).
Remove the 2 setscrews (4).
Lift the top cover (5) and pull out the motor
connector (6). Remove the top cover.
Remove the 3 setscrews (7) and remove the belt
cover (8).
NOTE:
When attaching the belt cover, engage the hooks
with the motor cover.
Remove the 3 setscrews (9) and remove the
motor cover (10).
Remove the 4 hinge screws (11), washers (12),
rubber feet (13) and base washers (14). Remove
the base (15).
(1)
(2)
(3)
(4)
(4)
(5)
(6)
(7)
(7)
(8)
(10)
(9)
(9)
(11)
(15)
(11)
(11)
(11)
(12)
(13)
Follow the above procedures in reverse.
To attach:
To remove:
(14)