Janome 5060DC - Adjusting Stitch Width and Density for Buttonholes

36
7.0
2.5
• Adjusting the stitch density
Press the cursor buttons to move the cursor
under the stitch density (stitch length) valume.
Press the button to make the buttonhole stitch
denser q.
Press the button to make the buttonhole stitch less
dense w.
The stitch density can be varied from 0.2 to 0.8
depending on the selected buttonhole.
The default setting is “0.4”.
• Adjusting the stitch width
Press the cursor buttons to move the cursor
under the stitch width valume.
Press the button to decrease buttonhole width q.
Press the button to increase buttonhole width w.
The stitch width can be varied from 2.5 to 7.0
depending on the selected buttonhole.
The default setting is “5.0”.
Adjusting the Stitch Width and Density for
Buttonholes
q
w
q
w
Round-End Buttonhole
q Stitch pattern: 17
w Needle thread tension: 1 to 5
e Presser foot: Automatic buttonhole foot R
q
ew
q
ew
Fine Fabric Buttonhole
q Stitch pattern: 18
w Needle thread tension: 1 to 5
e Presser foot: Automatic buttonhole foot R
The sewing procedure is the same as the square
The sewing procedure is the same as the square
buttonhole. The stitch width can be varied from 2.5 to 5.5.
To change the stitch width or stitch density, refer to the
section above.
buttonhole. The stitch width can be varied from 2.5 to 5.5.
To change the stitch width or density, refer to the section
above.
0.8
0.2